dbba662c

9.3.15. Dismantling and assembly of a power shaft

Design of a power shaft

1 — Collars
2 — the Boot
3 — the Spring washer

4 — the Hinge
5 — the Plug

 PERFORMANCE ORDER

  1. Remove a power shaft (see the Section Removal and installation of power shafts of the forward bridge).
  2. Remove both fixing collars (1) and shift a rubber boot (2) back.
  3. Unclench a spring washer (3) and by means of the hammer with soft brisk bring down a hinged hub (4) from a shaft pin.
  4. By means of a suitable press dismantle the plug (5).
  5. Carefully wipe the removed components, replace defective knots.
  6. Installation is made upside-down, - the plug (5) before landing to a shaft should be warmed up to the temperature of 160 ÷ of 180 °C. Do not forget to fill hinged knot durable lubricant (000 989 63 51).