dbba662c

9.3.12. Removal and installation of power shafts of the forward bridge

Details of installation of assembly of a hinged casing with a power shaft

2 — the Holder of a sealing element
3 — the Top bolt of an axis of turn of a wheel
4 — the Rotary fist
5 — Assembly of a hinged casing with a power shaft

9, 10 — Adjusting washers
11 — the Carving stopper

Dismantle of an epiploon of a power shaft and vypressovyvaniye of a tip of steering draft

1 — the Tip of steering draft
7 — the Epiploon of a power shaft

8 — the bearing Plug

Dismantle of a power shaft

5 — the Hinged casing

6 — the Nave

 PERFORMANCE ORDER

  1. Remove a support of the brake mechanism and a brake disk (see the Head Tormoznaya and auxiliary systems).
  2. Turn out a damper of the steering drive.
  3. Remove the executive cylinder of the drive of blocking of differential (see the Section Removal, installation and adjustment of executive cylinders and components of the mechanism of the drive of blocking of interwheel differentials).
  4. Release a fixing koronchaty nut and a vypressuyta from the rotary lever a tip of steering draft (1). Estimate a tip condition, in case of need prepare replacement.
  5. Previously having measured length of a persistent bolt of restriction of an angle of rotation of a wheel, separate the holder of a sealing element (2).
  6. Remove the top bolt of an axis of turn of a wheel (3) and at once tie up to it an adjusting washer (9).
  7. From below remove the rotary lever (4), - also tie up to it an adjusting washer (10).
  8. Remove a hinged casing assembled with a power shaft (5), - tie up conical roller bearings to a rotary bolt / lever.
  9. Remove an epiploon of a power shaft (7).
  10. Remove the plug of the bearing (8).
  11. Priboltite a lock key (717 589 00 31 00) to a nave of a wheel (6) also clamp it in a vice.
  12. Remove a protective cover.
  13. Unblock and release an external stupichny nut.
  14. Remove a lock plate.
  15. Release an internal pro-carved nut and release a power shaft from a hinged casing, - try not to damage a rotor of the wheel ABS sensor.
  16. Carefully wipe all removed components and visually estimate their condition, - in case of need prepare replacement.
  17. Installation is made upside-down, - remember that pro-carved nuts are subject to replacement without fail. Before installation do not forget to fill a protective cover of a nave lubricant for the chassis.
  18. In conclusion make adjustment of wheel and rotary bearings (see the Sections Adjustment of Wheel Bearings of a Forward Axis and Adjustment of Bearings of Rotary Knots) and the angles of installation of wheels (see the Head Podvesk and steering).