dbba662c

9.2.6. A detachment and connection of driveshafts on the transfer case

Details of installation of the transfer case (on the example of a series 750.653)

1 — the Transfer case
2 — the switching Lever *
3 — the Boot *
4, 16, 18 — Driveshafts
5, 15 — Screws
6 — the Washer
7 — Rubber pillows
8, 12 — Sealing rings
9 — the Stopper of a jellied opening
10 — the Angular drive *
11 — a speedometer drive Shaft *

13 — the Drain stopper
14 — the Basic lever
17, 19, 25 — Nuts
20 — the Hollow bolt of nipple connection
21 — Sealing washers
22 — the Line of a pneumatic path
23 — the Socket
24 — the Line of pumping
S76/7 — the Sensor switch of the indicator of blocking of interaxal differential

* On the considered models is absent

Detachment

Output shaft of the drive of the forward bridge

 PERFORMANCE ORDER

  1. Transfer the AT selector lever to situation "N", turn on the transfer case in the mode of the movement along the road.
  2. Поддомкратив the car, hang out the left forward wheel.
  3. Rotating the hung-out wheel, you otboltit the driveshaft (18), take him aside and tie up.

Shaft of the drive of the transfer case

 PERFORMANCE ORDER

  1. Transfer AT and the transfer case to neutral provisions.
  2. Rotating a power shaft (16), an otboltita it, take him aside and tie up.

Output shaft of the drive of the back bridge

 PERFORMANCE ORDER

  1. Transfer the AT selector lever to situation "N", turn on the transfer case in the mode of the movement along the road.
  2. Поддомкратив the car, hang out the left back wheel.
  3. Rotating the hung-out wheel, you otboltit the driveshaft (4), take him aside and tie up.

Connection

Nuts of fastening of driveshafts are subject to replacement without fail!


 PERFORMANCE ORDER

  1. Develop an entrance flange on the transfer case a yellow tag down.
  2. Having deployed driveshafts green tags up, connect them to the flanges on the transfer case.
  3. Track that NEW fixing nuts were tightened with the required effort.