dbba662c

9.2.2. Removal and installation of the module of management of the transfer case

Details of installation of the module of management of the transfer case (N15/7)


 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. Remove the central console (see the Head Kuzov).
  4. Remove the back module of activation and perception of a signal (SAM)/assembly the block of safety locks and the relay.
  5. Disconnect an electrical wiring, give four fixing nuts and remove the module of management of the transfer case (N15/7).
  6. Installation is made upside-down.
  7. In conclusion do not forget to deactivate the service mode of the TELE AID system (at the corresponding complete set) and to make cleaning of the processor memory of system of onboard self-diagnostics.