dbba662c

8.7. Removal and installation of the selector module (ESM)

Details of installation of the electronic selector module (ESM)

1 — the Cable of the drive of blocking of ignition
1b — the Lock uvula
1s — the Socket
2 — the Bolt
3 — the Intermediate lever
4 — Sealing laying

5 — the Socket
6 — the Safety lock
7 — the Nest
8 — Draft of switching
N15/5 — ESM

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. Disconnect draft of the drive of switching (8) from the intermediate lever (3) from below.
  4. Remove the central console
  5. Wring out a lock uvula (1b), turn the socket (1s) on 90 ° in the direction specified by an arrow and, having pulled, disconnect a cable of blocking of EIS (1) from the selector module (N15/5).
  6. Disunite the socket (5).
  7. Turn out bolts (2).
  8. Remove the selector module (N15/5), check a condition of its sealing laying (4), - in case of need make replacement.
  9. Installation is made upside-down.
  10. In conclusion turn off the service mode of the TELE AID system and make cleaning of memory of the module of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).