- On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
- Disconnect a negative wire from the battery.
- The car also establish to Poddomkratta it on props.
- Disconnect from cases of the engine and transmission a jellied tube (2).
- Turn out a stopper (9) and merge transmission liquid, - at once estimate ATF condition, in case of need make its replacement (see the Head the Current leaving and service).
- Release bandages, separate an electrical wiring plait from a jellied tube and disunite the contact socket (X22/2), - prepare replaceable bandages.
- Turn out the sensor of output turns of transmission (B49), - in case of need prepare a replaceable sealing ring.
- Turn off the left and right oil pipelines going to the oil cooler.
- Release a fixing collar and remove draft of switching (7).
- Uncover (12) and disconnect the hydrotransformer from a driving disk.
- Prop up transmission a special jack.
- Remove a cross beam assembled with a back support of a suspension bracket of the power unit (6).
- The driveshaft (5) from an output flange of transmission and the transfer case also take Otboltite from under the car, - in case of need previously you otboltit and incline transmission (see below), - and tie up it to bottom elements.
- Remove the stabilizer of cross stability (see the Head Podvesk and steering).
- Release a fastening bandage to a frame of the plait of an electrical wiring laid to the left of transmission.
- Otboltite tire of grounding (4).
- Turn out bolts of fastening of AT to the engine and lower it at an angle, - if did not do it yet, remove the driveshaft.
- In case of need by means of special strippers take the hydrotransformer from transmission.
- Installation is made upside-down, - before installation the driving flange of the hydrotransformer should be greased slightly. Track correctness of installation of the driveshaft.
- In conclusion deactivate the service mode of the TELE AID system and make cleaning of the processor memory of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).
|
|