dbba662c

6.2.13. Removal and installation of the module of management of injection of fuel (ECM ME-SFI)

Details of installation of the module of management of fuel injection (1 of 2)

1, 2 — the Bolt
3 — the Basic arm of the module

N3/10 — (ECM ME-SFI)

Details of installation of the module of management of fuel injection (2 of 2)

4, 5, 6, 7 — Sockets


 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Disconnect a negative wire from the battery.
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.


    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery
  1. Remove the forward panel of a carpet in a passenger foot well.

  2. Remove assembly of the module of activation and perception of a signal (SAM) with the forward assembly block of safety locks/relay (see the Head Onboard electric equipment), - do not disconnect an electrical wiring.

  3. Turn out bolts (1 and 2) and remove a basic arm (3) ECM.
  4. Disunite sockets of an electrical wiring (4, 5, 6, 7 and 8), - do not forget to release clamps where they are provided.
  5. Remove ECM ME-SFI (N3/10).
  6. Installation is made upside-down, - track correctness of making and connection of an electrical wiring.
  7. In the conclusion (at the corresponding complete set) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID) and make cleaning of the processor memory of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).