dbba662c

6.2.10. Removal and installation of the sensor of a reserve of fuel

Details of installation of the sensor of a reserve of fuel (all models)

1 — the Fuel tank
2 — the fuel reserve Sensor
3 — the Sealing ring

4 — the Soaking-up fuel-supply line
5 — the Ventilating hose
6 — electrical wiring Sockets

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.


    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery
  1. If the fuel tank (1) is filled, pump out from it about 8 liters of fuel (see the Section Depletion of the Fuel Tank).
  2. Remove the panel carpet a covering in the luggage compartment of the car.
  3. Turn off a cover of the sensor of a reserve of fuel (2).
  4. Disconnect from the sensor (2) the soaking-up fuel-supply line (4) and a ventilating hose (5), - a zakuporta the open ends of unions.
  5. Disconnect an electrical wiring (6) and take assembly of the sensor (2) from the fuel tank.
  6. Installation is made upside-down.
  7. In conclusion deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID) and make cleaning of the processor memory of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).