dbba662c

5.1.11. Removal and installation of a heater of the block of the engine (at the corresponding complete set)

Details of installation of a heater of the block of the engine (model 463.322/323, HP1 code)

1 — the electrical wiring Socket
2 — the Spring clamp
3 — the Cover
4 — an engine block heater Electrical wiring

5 — the Bandage
6 — the Collar
7 — the Basic arm
8 — an engine block Heater

 PERFORMANCE ORDER

  1. On models with the ET2 code activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. The car also establish to Poddomkratta it on props.
  4. Remove protection of a case.
  5. Having turned a cooling system cover to the first emphasis, dump residual pressure in a cooling path.
  6. Empty the cooling system (see the Head the Current leaving and service).
  7. Remove an additional heater (see the Section Removal and installation of the circulation pulser of an additional heater of STH (at the corresponding complete set)).
  8. Remove the air distributor (see the Head of the Power supply system and production of the fulfilled gases).
  9. Release the socket (1) of a spring clamp (2), then uncover (3).
  10. For the purpose of release of a plait of an electrical wiring (4) heaters release a bandage (5) and remove a collar (6) from a basic arm (7), - the bandage is subject to replacement without fail.
  11. Remove assembly of a heater (8), - prepare a replaceable sealing ring.
  12. Installation is made upside-down.
  13. In case of need add fresh liquid in the GUR tank and pump over a hydraulic path of the steering amplifier.
  14. Remove air from a path of the cooling system (see the Head the Current leaving and service) and check the corresponding components for existence of signs of development of leaks.
  15. On models with the ET2 code deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  16. In conclusion make cleaning of the processor memory of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).