dbba662c

13.7.3. Removal and installation of antenna amplifiers

Amplifier of the antenna of the radio receiver/TV-tuner

Details of installation of the amplifier of the antenna of the radio receiver/TV-tuner

1 — the Socket of a cable of the antenna pasted on glass
2 — the Nut with a nakatka
3 — the Antenna cable

4 — Fixing nuts
A2/51 — the Antenna amplifier
X39/32 — the Socket of a plait of giving of food

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Disconnect a negative wire from the battery.
  3. Remove a ceiling upholstery (see the Head Kuzov).
  4. Disunite the socket (X39/32) of a plait of giving of food.
  5. Release a nut with a nakatka and disunite the socket of an antenna cable (3).
  6. Give fixing nuts (4) and remove the amplifier (A39/32) of the antenna of the radio receiver/TV-tuner
  7. Installation is made upside-down, - on models of the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  8. In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine) and perform procedures of basic programming.

Amplifier of the antenna of an IK-receiver of the uniform lock

Details of installation of the amplifier (A2/65) of the antenna of an IK-receiver of the uniform lock

 PERFORMANCE ORDER

  1. Remove the dashboard (see the Head Kuzov).
  2. Remove the alarm electrical wiring going from the antenna module (A2/65).
  3. Accurately release a connecting wire of the antenna from a clamp on a windshield.
  4. Disconnect an electrical wiring from the antenna amplifier (A2/65).
  5. Release fixture, separate the amplifier (A2/65) from the body panel and remove it from the car.
  6. Installation is made upside-down, - do not forget to replace sealing strips from porous rubber.