13.6. Systems of additional safety (SRS)
Removal and installation of modules of frontal safety cushions
|
The failed modules of safety cushions before utilization are subject an obligatory discharge, - ask for the help specialists of car service. |
Driver's safety cushion
Details of installation of the module of a driver's safety cushion on release models till 30.06.02
Details of installation of the module of a driver's safety cushion on release models from 01.07.02
|
- Shift a steering wheel against the stop back.
- On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
|
- Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.
|
|
- Turn out fixing bolts (2).
- On release models till 30.06.02 raise the module of a driver's safety cushion (1) and disunite the socket (5) of an electrical wiring of a multipurpose steering wheel (5). Also disconnect an electrical wiring from igniter (R12/13) of a safety cushion.
- On release models from 01.07.02 raise the module (1), release clamps (3) and disunite sockets (5) both igniters (R12/13 and R12/14), and also the socket (4) of a multipurpose steering wheel.
- Remove the module of a driver's safety cushion (1).
- Installation is made upside-down, - track reliability of fixing of contact sockets.
|
|
On release models from 01.07.02 joining of sockets (5) has to be followed by distinct click. |
|
- On models of the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
- In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine) and perform procedures of basic programming.
|
|
Passenger safety cushion
Details of installation of the module of a passenger frontal safety cushion
|
- On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
|
- Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.
|
|
- Remove a ware box (see the Head Kuzov).
- Disconnect an electrical wiring from the initiator of a gas generator, - at connection track reliability of a zashchelkivaniye of the socket.
- Give nuts of screws of fastening of assembly brackets (1) (on two screws on each bracket).
- Turn out screws (3) fastenings of the handle installed on dashboards.
- Turn out screws (4) fastenings of the module of a passenger safety cushion (2) to the bearing dashboard arm.
- Remove the module (2) assembled with a basic arm.
- In case of need separate the module (2) from an arm.
- Installation is made upside-down, - at the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
- In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine) and perform procedures of basic programming.
|
|