dbba662c

13.5.3. Removal and installation of indexes of turns

Regular indexes

On AMG complete set models of a lens of indexes of turns are closed outside by a protective lattice

Lens (1) of the index of turn on models of a basic equipment

Design of the index of turn

2, 3 — electrical wiring Sockets
4 — the Lamp holder

5 — the Basic platform

 PERFORMANCE ORDER

  1. Remove the corresponding block headlight (see the Section Removal and installation of block headlights, replacement of lamps, adjustment of the direction of optical axes).
  2. On models 463.246 remove a protective lattice (A) of a lens of the index of turn.
  3. Having hooked, remove from a basic platform (5) a lens (1).
  4. Mark, disunite and insulate sockets (2 and 3) of an electrical wiring.
  5. Keeping from a provorachivaniye of a nut of fixing screws through a window under landing of a block headlight, release fixture and remove a basic platform (5) of the index of turn assembled with a lamp holder (4).
  6. Installation is made upside-down.

The repeaters which are built in assemblies of door mirrors

Details of installation of the door mirror of the repeater of the index of turn which is built in assembly (1 of 3)

1 — a mirror Lens
2 — the Socket of an electrical wiring of heating of a mirror

8 — the Repeater of the index of turn

Details of installation of the door mirror of the repeater of the index of turn which is built in assembly (2 of 3)

10 — the Flat socket

11 — the Shtekerny socket

Details of installation of the door mirror of the repeater of the index of turn which is built in assembly (3 of 3)

3, 7 — Screws
4 — the Regulator
5 — the Shtekerny socket

6 — the Support of a lamp of onboard illumination
9 — the Lamp of onboard illumination

 PERFORMANCE ORDER

  1. Against the stop drown a lens of a mirror (1), then accurately release it from clamps.
  2. On models without device of automatic brightness control of reflection disunite the socket (2) electrical wirings of heating of a mirror.
  3. On models with the device of automatic brightness control of reflection disunite the flat socket (10) and the shtekerny socket (11).
  4. Turn out fixing bolts (3) and remove assembly of the regulator (4).
  5. Remove the support (6) of the repeater of the index of turn equipped with a bayonetny lock.
  6. Turn out screws (7) and remove a lamp of the repeater (8).
  7. In case of need release clamps and take from a mirror casing a lamp of onboard illumination (9).
  8. Installation is made upside-down.