dbba662c

13.3.3. Removal and installation of the handle of the switch and actuation mechanisms of the drive of correction of the provision of block headlights

Details of installation of the handle of the drive of adjustment of an inclination of optical axes of headlights

1 — the switch Handle
2 — the Assembly bracket
3 — the Remote plug

4 — the plug Through passage
8 — the Opening in a partition

Details of installation of the actuation mechanism of the regulator of an inclination of optical axes of headlights

5 — the Pilot line
6, 7 — Bandage clamps

9 — the Actuation mechanism
10 — the Cover

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.

    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery

  1. Turn the handle (1) of the drive of the hydroproofreader in situation "0" and, without rotating, remove it from the dashboard.
  2. Remove the left lower section of finishing of the dashboard (see the Head Kuzov).
  3. Remove an assembly bracket (2).
  4. Shoot the left group of switches of the dashboard (see the Partition Group of Switches at the left with dashboards).
  5. Remove a face cover of a steering column (see the Head Kuzov).
  6. Remove the remote plug (3).
  7. Remove a forward decorative lattice (see the Head Kuzov).
  8. Remove a block headlight (see the Section Removal and installation of block headlights, replacement of lamps, adjustment of the direction of optical axes).
  9. Remove a front bumper (see the Head Kuzov).
  10. Remove a loker of protection of a wheel arch (see the Head Kuzov).
  11. Turn out forward fixing screws and uncover (10) and the rubber sealant established under it.
  12. Remove assembly of the vacuum amplifier of brakes (see the Head Tormoznaya and auxiliary systems).
  13. Open the plug (4) through passage and take from it a sealant from porous rubber. Having pulled forward, remove the plug (4).
  14. On models 463/323 remove the tank of liquid of washing of glasses (see the Head Kuzov).
  15. Release bandages (6 and 7) and separate a pilot line (5) from the panel of a wheel arch and a cross beam of a radiator, - bandages are subject to replacement without fail.
  16. Push the actuation mechanism of the regulator (9) in a window in the panel of a front and remove it from the car, having carried out through openings in a partition (8) and a wheel arch and having released from the plug (4) through passage, - try not to bend hydraulic lines!
  17. Installation is made upside-down, - on models of the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  18. In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine).
  19. Check correctness of adjustment of an inclination of optical axes of headlights, in case of need make the corresponding adjustment (see Specifications).