dbba662c

12.3.8. Removal and installation of a face cover of a steering column

Details of installation of a face cover of a steering column on release models till 30.06.02 (1 of 2)

2 — the Lower section of finishing of the dashboard
3 — the Switch of adjustment of provision of headlights
A45 — the Contact cable reel

S4 — Assembly of understeering switches
S40/4 — the Switch of a tempostat
S93/2 — the Right understeering switch

Details of installation of a face cover of a steering column of release till 30.06.02 (2 of 2)

4 — electrical wiring Sockets
5 — the Cylindrical casing
6 — Fixing bolts

7 — the Face cover
N73 — the EIS/EZS Module

Details of installation of a face cover of a steering column of release from 01.07.02

8 — Assembly of understeering switches

9 — Clamping the screw

 PERFORMANCE ORDER

  1. Develop a steering wheel in the situation corresponding to the rectilinear movement.
  2. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.

    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery
  1. Remove a steering wheel (see the Head Podvesk and steering).
  2. Remove the left lower section (2) finishings of the dashboard (see the Section Removal and installation of the left lower section of finishing of the dashboard).
  3. Remove the contact cable reel (A45) of a horn and driver's safety cushion (see the Head Podvesk and steering).
  4. Remove assembly of the combined understeering switches (S4 or 8).
  5. On release models till 30.06.02 disunite sockets (4) of the EIS/EZS (N73) module and a plait of an electrical wiring of the dashboard.
  6. Remove a combination of devices (see the Section Removal and installation of a combination of devices).
  7. On release models till 30.06.02 remove a cylindrical casing (5) steering columns, - try to remember routes of laying of an electrical wiring.
  8. Turn out bolts (6) and remove a face cover (7) steering columns.
  9. Installation is made upside-down, - at the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  10. In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine) and enter the required basic settings of the onboard equipment.