dbba662c

12.3.11. Removal and installation of a combination of devices

Release models till 30.11.00

Details of installation of a combination of devices (release model till 30.11.00)

1, 2 — the electrical wiring Socket
And — the Socket is disunited

In — the Socket is connected
A1 — the Combination of devices

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Pass a film-making hook in a gap between the dashboard and a combination (A1), - try not to damage plastic.
  3. Release and disunite sockets of an electrical wiring (1 and 2).
  4. Release a combination (A1) from the panel.
  5. Installation is made upside-down.

Release models from 01.12.00

Details of installation of a combination of devices (release model from 01.12.00)

1 — the Facing slip
2 — the electrical wiring Socket

A1 — the Combination of devices

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  2. Transfer an adjustable steering column to extreme lower situation and against the stop nominate to yourself a steering wheel.
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.

    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery

  1. Hooking a suitable wedge, release four clamps and remove a facing slip (1).
  2. Pass film-making hooks in a combination of devices (A1), develop them the bent ends outside, against the stop push inside and record in guides, having slightly wrung out outside.
  3. Develop hooks on 90 ° down and, having pulled, release a combination (A1) from the dashboard.
  4. Disunite the socket (2) and finally remove a combination of devices (1).
  5. Installation is made upside-down, - at the corresponding complete set (ET2 code) deactivate the service mode of the TELE AID system (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  6. In conclusion make reading of the DTC codes and cleaning of memory of system of onboard self-diagnostics by means of the STAR DIAGNOSIS scanner (6511 1801 00) (see the Head Sistemy of electric equipment of the engine).