dbba662c

12.2.4. Removal and installation of the lock of a cowl

In total самоконтрящийся fixture is subject to replacement without fail!

Except models 463.333

Details of installation of the lock of a cowl (except models 463.333)

1, 3 — Bolts
2 — the Top cross beam of the ancestor
4 — the Lock

5 — the Driving cable
6 — the Adjusting screw
7 — the Carving nipple

 PERFORMANCE ORDER

  1. Remove a forward lattice (see the Section Removal and installation of a forward lattice).
  2. Turn out bolts (1) in the top cross beam of a front (2), - slightly incline a beam for the purpose of ensuring the best access to nuts from its lower party back.
  3. Disconnect the grounding tire from a beam (2).
  4. Having released a cable clamp the drive of an otpuskaniye of a latch of the lock (5), remove a beam (2).
  5. Weaken the adjusting screw (6) and, having pulled, disconnect a cable (5) from castle assembly (4).
  6. Release screws (3) and remove the lock (4).
  7. Installation is made upside-down, in case of need replace washers. Track that the carving nipple (7) of a cable (5) provided the minimum free wheeling of a cowl.

Model 463.333

Details of installation of the lock of a cowl (model 463.333)

1, 5 — Bolts
2 — the Driving cable

3 — the Lock
6 — the Top cross beam of the ancestor

 PERFORMANCE ORDER

  1. Remove a forward lattice (see the Section Removal and installation of a forward lattice).
  2. Turn out bolts (5) in the top cross beam of a front (6) and remove the last, having released a cable from a clamp.
  3. Turn out bolts (1), - in case of need prepare replaceable washers.
  4. Disconnect a driving cable (2) and remove assembly of the lock (3).
  5. Installation is made upside-down, - track that marking in the form of an arrow on castle assembly was turned to the left. Connect a cable to the lock only after installation of the last.