dbba662c

12.2.25. Removal and installation of window frames of door assemblies

Forward doors

Order of removal of a window frame of a forward door

1 — the Rubber sealant
2 — the Window frame
3 — the Facing frame

4 — the Bolt
Shooters — Fixing screws

 PERFORMANCE ORDER

  1. Remove glass of a door window (see the Sections Removal and installation of window frames of door assemblies and Removal and installation of elements of a glazing of a body).
  2. Release a rubber sealant (1) from a window opening, - in case of need prepare a replaceable sealing element.
  3. Turn out screws (shooters) of fastening of a window frame (2).
  4. Release from clamps and remove a facing frame (3) of a window opening.
  5. Turn out screws (4) at the left and on the right in the lower part of a frame (2), then take the last from a window opening, having pulled up and outside.
  6. Installation is made upside-down, - the facing frame has to be established before fixing of a frame.
  7. In conclusion make sure of smoothness of the course of lowering/lifting of door glass.

Back doors

Window frames of back doors are removed assembled with glasses.

Order of removal of a window frame of a back door (1 of 2)

1, 2 — Sealing elements
3 — the Window frame

4 — the Facing frame
Shooters — Fixing bolts

Order of removal of a window frame of a back door (2 of 2)

5, 6, 7 — Bolts

8 — Glass

 PERFORMANCE ORDER

  1. Remove an internal upholstery of a door (see the Section Removal and installation of an internal upholstery of door assemblies).
  2. Remove the lower sealing element (1) of a window opening, - try not to break off a uvula of a forward clamp. The damaged sealant is subject to replacement.
  3. Release from a window opening a rubber sealant (2).
  4. Turn out bolts (shooters) of fastening of a frame (3).
  5. Release clamps and remove a facing frame (4).
  6. Establish into place a rubber sealant (2) and completely lift glass (8).
  7. Accurately remove film insulating covering of a door (see the Section Removal and installation of an internal upholstery of door assemblies), - the damaged film should be replaced.
  8. Turn out fixing bolts (5 and 6) at the left and on the right in the lower part of a frame (3).
  9. Take measures against falling of glass and turn out screws (7) of its fastening to the regulator.
  10. Having given outside, accurately take a frame (3) assembled with glass (8) from a window opening.
  11. Installation is made upside-down, - the facing frame has to be established before fixing of a frame.

Tightening of screws (7) has to be made only after the lifted glass (8) is leveled in a window opening.

  1. In conclusion make sure of smoothness of the course of lowering/lifting of door glass.