dbba662c

11.4.6. Removal and installation of a steering wheel

Details of installation of a steering wheel

1 — the Socket of an electrical wiring of the device of heating of a steering wheel
32 — the Steering wheel

32s — the Screw with a secret head

Contact cable reel (A45) of a steering wheel


 PERFORMANCE ORDER

  1. Develop a steering wheel (3) in the situation corresponding to the rectilinear movement.
  2. Take a key from the ignition lock, - the device of electronic blocking of a column (ESC) has to work.
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.

    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery
  1. Remove from a steering wheel the safety cushion module (see the Head Onboard electric equipment).
  2. On models of the corresponding complete set (release from 01.07.02 with the VL0 code) disunite the socket (1) electrical wiring of the device of heating of a steering wheel.
  3. Having recorded a steering wheel (32) not movably, turn out the screw with a secret head (32s), - the screw is subject to replacement without fail.
  4. Passing a safety cushion electrical wiring through an opening through passage, remove a steering wheel, previously having marked its adjusting situation on a column shaft.
  5. Visually estimate a condition of the contact cable reel (A45), in case of need make its replacement (see the Section Removal and installation of the contact cable reel of a steering wheel).
  6. Installation is made upside-down, track correctness of combination of the landing tags put in the course of dismantle of a wheel.