dbba662c

11.4.10. Removal and installation of a steering column with the adjustment electric drive

In total самоконтрящийся fixture is subject to replacement without fail!

Installation details electrically an adjustable steering column (1 of 3)

3 — electrical wiring Sockets
4 — the Remote pipe
5 — a column Sleeve

6 — the Bearing bracket
7 — the Top bolt
8 — Nizhny Novgorod a bolt

Installation details electrically an adjustable steering column (2 of 3)

4 — the Remote pipe
11, 12 — Screws

13 — Pins

Installation details electrically an adjustable steering column (3 of 3)

1 — the Central cardan hinge
2 — the Nut
9 — the Screw

10 — the Rubber boot
14 — the Steering shaft

 PERFORMANCE ORDER

  1. On models of the corresponding complete set (ET2 code) activate the service mode of system of an emergency call of TELE AID (see the Section Activation/deactivation of the Service Mode of System of an Emergency Call of TELE AID).
  1. Turn on the auxiliary accumulator and connect it to the regular battery, then disconnect from the last a negative wire.

    7 — the Auxiliary accumulator
    8 — the Plug of a positive wire of the module
    9 — the Plug of a negative wire of the module
    W10 — Grounding of the battery
  1. Develop in rectilinear situation and remove a steering wheel (see the Section Removal and installation of a steering wheel).
  2. Remove a combination of devices (see the Head Kuzov).
  3. Uncover under the dashboard at the left.
  4. 7 Remove assembly of the lock of ignition (EIS) (see the Head Onboard electric equipment).
  5. you nimit a cover of a casing of a steering column.
  6. At the corresponding complete set remove a knee emphasis.
  7. Disunite sockets (3) electrical wirings.
  8. Remove the switch of switching of the modes of functioning of lighting fixtures (see the Head Onboard electric equipment).
  9. Turn out bolts (12 and 11).
  10. Remove a remote pipe (4).
  11. Turn out top (7) and the lower (8) bolts.
  12. Give a nut (2) and take a bolt (9) of the central cardan hinge (1).
  13. Having hooked, remove the hinge (1) from a steering shaft (14).
  14. Having pulled in salon, remove a sleeve of a steering column (5), - try not to damage a boot (10).
  15. Installation is made upside-down, - do not forget to put a pin (13) in a reception nest of the bearing bracket (6).
  16. At the corresponding complete set deactivate the service mode of the TELE AID system.
  17. In conclusion make cleaning of the processor memory of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).