dbba662c

10:19. Removal and installation of components of the hummock drive of the parking brake

Design of the hummock drive of the parking brake (1 of 2)

1 — the Bearing plate
2 — Driving cables
3 — the Rubber plug through passage
4 — the Arm

5 — the Lever of raising of the parking brake
38 — Adjusting nuts
and — Clamps

Design of the hummock drive of the parking brake (2 of 2)

11 — Clamps


 PERFORMANCE ORDER

  1. Uncover the lever of raising of the parking brake (5).
  2. Remove the central console and the left side panel of its finishing (see the Head Kuzov).
  3. Turn off adjusting nuts (38).
  4. Take off boots of the parking brake (see the Section Replacement of Boots of the Parking Brake).
  5. Release fixture of fixing of a driving cable (2) to the bearing plate (1).
  6. Release clamps (a) of fastening of cables (2) to the car bottom.
  7. Release cables (2) from the plug (3) through passage in the bottom.
  8. release cables (2) from a basic arm (4).
  9. Carefully wipe all components and visually estimate their condition. In case of need make replacement.
  10. Installation is made upside-down, - pay attention to a difference in length of cables. For the purpose of simplification of a transmission of cables (2) in openings in the plug (3) through passage grease them with soap solution. Grease a carving part of fixture of clamps of fastening of cables to the bottom with anticorrosive structure.
  11. In conclusion adjust the drive of the parking brake (see the Section Adjustment of the Drive of the Parking Brake).