10:16. Removal and installation of supports of brake mechanisms
Brake mechanisms of forward wheels
Details of installation of a support of the fixed type of the brake mechanism of a forward wheel
|
- Disconnect from a support (31) the brake line (5), - at once to a zakuporta the open end of a tube.
- Release the sensor of wear of blocks (S10/1 or S10/2) from a contact block (S10/1x1 or S10/2x1).
- Turn out a contact block (S10/1 or S10/2) from a support (31).
- Otboltite a support (31) from assembly of a rotary fist.
- Installation is made upside-down, - do not forget to replace the microencapsulated bolts (35).
- In conclusion pump over a hydraulic path (see the Section Pumping of the Brake System) and check serviceability of functioning of brakes.
|
|
Brake mechanisms of back wheels
Details of installation of a support of the floating type of the brake mechanism of a back wheel (1 of 2)
Details of installation of a support of the floating type of the brake mechanism of a back wheel (2 of 2)
|
- Press and disconnect from a support (2) a brake hose (1).
- Separate a support (2) from an anchor bracket (6), - prepare the replaceable hidden directing microencapsulated bolts (3).
- Disconnect the sensor of wear of brake shoes (it is installed only in the mechanism of the right back wheel).
- By means of suitable adaptation wring out the piston (4) in the cylinder, - prepare for collecting the liquid which is forced out from the GTTs tank.
- Smooth out a support a special brush.
- Check a support (2) for existence of signs of development of leaks, check a condition of a boot of the piston (4). Replace defective components (support/boot).
- Installation is made upside-down, - do not forget to replace the microencapsulated bolts (3).
- In conclusion pump over a hydraulic path (see the Section Pumping of the Brake System) and check serviceability of functioning of brakes.
|
|