dbba662c

10:10. Removal and installation of rotors of wheel ABS sensors

Forward sensors

Details of installation of a rotor of the forward wheel ABS sensor

1 — the Rotor

2 — the Power shaft

 PERFORMANCE ORDER

  1. Make dismantling of a power shaft (2) (see the Head the Transmission line).
  2. Clamp a shaft (2) in a vice.
  3. Having pierced on 2 mm and having pulled down a chisel, remove a rotor, - try not to damage a shaft.
  4. Before landing to a shaft warm a replaceable rotor up to the temperature about 80 °C, then use a suitable mandrel.

Back sensors

Details of installation of a rotor of ABS of external landing on models with drum brake mechanisms of back wheels

1 — the Rotor of the wheel sensor
2 — the Half shaft

Details of installation of a rotor of ABS of internal landing on models with drum brake mechanisms of back wheels

2 — the Half shaft
3 — the Pro-carved nut with the built-in rotor

Details of installation of a rotor of ABS on models with disk brake mechanisms of back wheels

1 — the Rotor of the wheel sensor
2 — the Half shaft


 PERFORMANCE ORDER

  1. Remove a half shaft (2), sort it (see the Head the Transmission line) and clamp in a vice.
  2. By means of suitable adaptation remove a rotor (1) from a half shaft.

On models with internal landing of rotors turn off a pro-carved nut (see the Head the Transmission line).

  1. Installation is made upside-down.